mold construction design for core toggle multi shot molding

We have discussed the rotary table multi shot mold and rotary shaft multi shot mold before, so today we will talk about the two-color injection of the core toggle mold!

The core toggle multi shot molding process is the easiest, because the core and cavity of the mold do not need to be moved. Conversely, changing the geometry of the mold cavity by moving the slider. Check below pictures:

First inject material A into the cavity, at the same time the slider is in the fully extended position!

Then retracting the slider to reveal a new portion of the cavity!

After that, material B is injected into the reconfigured cavity through a separate gate (above the middle nozzle), the remaining gap is filled by moving the slider!

Then the plastic part hardens and ejected from the mold. Sequentially circulated as the above to continue the molding!

Adding a slider to the mold adds the cost of the tool, but it still can be much more cheaper than rotating platen or rotary shaft mold. Unfortunately, it can not produce the complex multi colored plastic parts.

We YUEYI Mold, China top multi injection mold maker, always here ready to service you, if you’re still looking for the good multi shot mold maker in China!

Lucia

lucia@yueyimold.com

Your good choice to have the quality mold in China!