标签： rotary stack mold

China stack turning mold supply

China stack turning mold maker

The advantage of the cube technology over other mold technologies is that the number of cavities for the same machine size can be doubled. Or in other words: for the same production lot, the size of the machine is almost halved.

In the stack turning technology, the mold rotation is performed with a horizontal rotary device in the form of a center plate. Plastic parts are produced in the first parting plane. When the mold is opened, they remain on the side of the moving center plate. For a fully opened mold, the center plate is rotated 180° and placed in the second parting plane. After closing again, the second component is injected in the second cavity where the parts are located on the center block.

When using stack-turning molds with 4 × 90° rotation, stations 2 (operator side) and 4 (non-operator side) can be simultaneously used for further production steps.

For example, station 2 can be used for cooling the molded parts and station 4 can be used for removal by a robotic system. Both functions take place without affecting the cycle time. Alternatively, station 2 can also be used for mounting (in-mold assembly) inside and outside the system.

Anyway, if you’re looking for the good multi material stack turning mold maker in China, then I’m sure we can be your another good choice!

Lucia

lucia@yueyimold.com

multi component cube mold

Leave a comment

rotating stack mold

Cube mold technology is distinct from traditional co-injection, because an inner layer is initially molded on one side of the cube, then rotated 180 degrees where the outer layer is over-molded. Both molding stages operate as conventional injection molding processes, which is simpler to set up, maintain, and run continuously in comparison to a more complex co-injection system. It’s comprised of two standard molds, with stacks designed to accurately and repeatably produce the individual layers of the part!

Cube mold technology provides competitive cycle times, this results in a dramatic reduction in part cost. We Focare, as innovative suppliers who bring state-of-the-art capabilities to high volume multi injection molding systems!

If you’re looking for the good multi injection cube mold maker in China, then I’m sure we can be your another good choice!

Lucia

lucia@yueyimold.com

co injection stack mold supply

Leave a comment

co injection stack mold China supply

Co injection molds is widely used in food and medical packaging, and we YUEYI provides co injection tooling based on innovated technology and systems – CO INJECTION STACK MOLD supply!

Co-injection stack mold can effectively solve the low output of customers’ two-color molded parts, greatly increase the production and reduce the consumption costs!

While compared to the single layer two color mold, the clamping force of co-injection stack mold will be 1.2-1.5 times! And the molding cycle time will be very similar, but the output efficiency is more than 1.8 times!

So what should be paid attention while doing the co-injection stack mold??

  • co injection stack molding with robotic transfer or the mold core part rotary is ok!
  • The mold requires high machining accuracy and high concentricity
  • The mold construction design must consider a reasonable and dedicated mold base system, hot runner system, load guidance system, two-way ejection system, linkage secondary molding system, etc.

We YUEYI team has accumulated over ten years of R & D and manufacturing experience in multi material molding technology. Foreseeably design and correct defects for various two-color parts, and support customers with the mature bi material molding technologies!!

If you’re troubled with the low output of your current 2k molding, if you’re still looking for the good 2k mold maker in China, then we can be your another good choice!

Lucia

lucia@yueyimold.com